Outlast® Mold-Buster™ Additive is an EPA-registered product designed to stop mold, mildew, and algae growth on paints, stains, coatings and adhesives. Its active ingredient is IPBC (3-iodo-2-propynyl butylcarbamate), a broad-spectrum fungicide with a distinguished history of use. Each 7.5 oz. container of Mold-Buster additive treats up to 5 gallons of paint or stain; or, it can be measured out in single gallon doses through the “view finder” strip on the side of the container. It does not alter the color of the coating and its thin viscosity allows easy mixing. The formulation is freeze-thaw stable, and has low odor and low VOC’s . Outlast Mold Buster is suitable for use in oil and/or water-based coatings, Mold-Buster should still be working hard to protect the paint film after 3 years or more.
WHAT ARE THE ADVANTAGES OF
OUTLAST MOLD BUSTER?
- No Odor
- Low VOCs – Approved for use in all 50 states
- Designed for use in virtually every water and oil based paint and stain product
- Approved for Interior and Exterior Use
- Excellent Freeze/Thaw Stability
- EPA Registered.
- Approved for consumer and professional use
- Mixes easily
- Broad Spectrum Protection
HOW IS OUTLAST MOLD BUSTER PACKAGED?
Outlast Mold Buster is stocked by Logfinish.com in 7.5 OZ plastic containers to treat 5 Gallons of paint or stain.
WHERE SHOULD OUTLAST MOLD BUSTER BE USED?
Mold Buster should be added to exterior finishes when a home is located on a river, stream or lake. It should also be used on homes located in forested areas where little sun reaches the home. Outlast Mold Buster should also be used on homes located in moist climates (i.e. Louisiana, Coastal Texas, Mississippi, Florida, Georgia, South Carolina, Hawaii, Coastal Washington and Oregon) If previous finishes have had problems with the growth of mold and mildew, always add Outlast Mold Buster. On the interior of homes use this product in Bathrooms, Spa Rooms, Greenhouses, Basements and any other areas with lots of moisture and poor humidity control.
Important Notice: OUTLAST MOLD BUSTER CAN NOT BE USED IN LIFELINE ADVANCE SATIN OR GLOSS TOPCOAT.
HOW DO YOU MIX OUTLAST MOLD BUSTER WITH YOUR FINISH?
Just pour the entire contents of the 7.5 ounce bottle of Outlast Mold Buster into five gallons of paint or stain and shake or stir thoroughly for 2-3 minutes. Apply the coating per the manufacturer’s directions. It is a violation of federal law to use Outlast Mold Buster in a manner inconsistent with its labeling. Outlast Mold Buster is designed to control surface mold and mildew and should be used only in the final coat of finish coat being applied at any one time.